![]() ![]() ![]() Let's assume we have two network interfaces ("eth0" and "eth1") and we want to bond them so they look like a single interface ("bond0"). You can load the module by issuing the following command as root : ~]# modprobe -first-time bonding. 5, perform the following steps: Check the physical interfaces and bond interface status. 1 (April 27, 2011) Bonding Mode: fault-tolerance (active-backup) (fail_over_mac active) Primary Slave: eth0 (primary_reselect always) Currently Active Slave: eth0 MII Status: up MII Polling Interval (ms): 0 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: eth0 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count. There is a fault-tolerance (active-backup) bond created over these two interfaces. nmcli is a command-line tool for controlling NetworkManager and reporting network status. If you ever wanted to check the status of a bonded interface configure in Linux (esp RHEL), you can check the status by running the following command.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |